Nvr configuration

NVR Setup Options - Modems, Routers, Switches - In the following article I will show a few of the configuration options that are available when setting up your NVR on your network. Click the Device Search button, and you can view the searched IP addresses at the top pane. For device security, please connect the NVR to the power adapter first and then connect the device to the power socket.

The rated input voltage matches the device power on-off button. Please make sure the power wire connection is OK.

Then click the power on-off button. Always use the stable current, if necessary UPS is a best alternative measure. An Ethernet cable is also needed during the initial setup for WiFi cameras) b. Power the IP cameras using a DC power adapter. An NVR is a Network Video Recorder and used to capture footage from security cameras.

For product details on where I picked up the hardware, check out my blog at NewfieBort. By default, the Setup Wizard starts once the device has loaded. Operating the Setup Wizard: 1.

Activation: Create a password to activate the system. For the first time to set up the system, please leave the settings of Singal Input Status by default. Choose the system language. Free to choose the option Start wizard when the device starts? This video will show you all the steps you need to setup your dvr system for remote view.

Keep It Simple - Do It Yourself. Best savings of the year! Connect a monitor and a mouse to the Hikvision DVR. Configure the IP, Subnet Mask and Gateway.

Open a Web Browser and insert the DVR IP. Open the ConfigTool and locate your NVR and IP Camera. Login to both using Internet Explorer. On the NVR , go to Settings-Network-WiFi Device Manage. On the IP Camera, go to Setup-Network-WiFi.

Note: For the models which have the PoE or built-in switch network interfaces, including N44PI, N48PI series NVR , the Internal NIC IPvAddress should be configured for the cameras connecting to the PoE or built-in switch network interface of the NVR. Click on the setup tab upper right corner, then camera and video on left site of the browser. There are a lot of options here that can be adjuste you will only need to adjust a few to start.

I am only concenred about the resolution, frame rate, and bit rate. Before setup the DVR to start recording your cameras,. After installing the HDD and connecting the cables,. Check the DVR Hard Drive.

The DVR can be configured and controlled locally, using the operator. When you are prompt to enter a passwor just press the OK button on the DVR or remote. The default admin password for the DVR is blank.

If you have already setup an admin password for your DVR, then enter this, then press OK. Digital Video Recorder User Manual 4.